Direct meer rijplezier met de EJK module voor EJK Electronic Jet Kit Gen 3.5 tune module for Yamaha MT-07 (2018+)
- Snel en eenvoudig te installeren – plug & play
- Voorgeprogrammeerd voor Stage 1-modificaties
- Geen laptop of software nodig
- Soepeler, krachtiger en responsiever motorkarakter
- Volledig instelbaar voor wie verder wil finetunen
De Electronic Jet Kit (EJK) voor EJK Electronic Jet Kit Gen 3.5 tune module for Yamaha MT-07 (2018+) is dé oplossing voor wie meer uit zijn motor wil halen zonder ingewikkelde software of dure dyno-sessies.
Dankzij plug & play aansluitingen is montage binnen enkele minuten geregeld. De module wordt geleverd met basisinstellingen voor Stage 1 (aftermarket uitlaat en luchtfilter), zodat je direct profiteert van een betere gasrespons en meer rijplezier.
Wie meer wil, kan eenvoudig finetunen via de overzichtelijke LED-zones (groen, geel, rood).
EJK Electronic Jet Kit Gen 3 tune module for Yamaha FZ-07 - MT-07 2015-2022
Less shop time means more ride time. The Electronic Jet Kit (EJK) is the No. 1 EFI controller on the market for installation time to riding with great performance. Plug and play does not just refer to connectors to make installation easy, but the EJK comes programmed and ready to go for stage 1 (after-market pipe and air cleaner) modifications. Forget downloading maps. Forget looking up settings. The EJK installs in mere minutes and you are off to a better, more powerful, smoother ride.
How does the EJK module work?
The EJK is Tuning-Made-Easy: that's the smart design of EJK. The EJK module is load-based and hence less model-dependent. Most modules are Alpha-N tuning: they use an Excel-style mapping with RPM and Throttle Position to decide which value to modify the fueling with. Clever but dumb at the same time, as it's not flexible.
The EJK is load-based, adjusting the fueling according to the engine's load. This results in the great advantages of the EJK: it's easy to use, very affordable, and it's a true tuning module for a wide range of use.
BASISINSTELLINGEN 8120147 EJK module Yamaha MT07 FZ07 2015-2022
|
|
| MODE: |
GREEN |
YELLOW |
RED |
|
|
|
#8 BLUE LED |
|
| FEATURES: |
GROEN BRANDSTOF |
GEEL BRANDSTOF |
ROOD BRANDSTOF |
ACCEL PUMP FUEL |
YEL LWR SW PT |
RED LWR SW PT |
ACCEL PUMP |
|
Controller settings for diagnostic purposes of running 0% change through entire drive cycle. These settings mean your vehicle is running on the stock ECU map.
| |
GRN @ 3.5 |
YEL @ 5 |
RED @ 5.5 |
G/B @ 3 |
Y/B @ 3.5 |
R/B @ 6 |
|
|
Recommended base settings for AKRAPOVIC TITANIUM Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle In
| |
GRN @ 5.5 |
YEL @ 5 |
RED @ 2.5 |
G/B @ 3.5 |
Y/B @ 3.5 |
R/B @ 6 |
|
|
Recommended base settings for MARTHY exhaust and DB Killer. Settings provided by Marthy.
| |
GRN @ 6.5 |
YEL @ 5 |
RED @ 4 |
G/B @ 3.5 |
Y/B @ 4.5 |
R/B @ 6.5 |
|
|
Recommended base settings for MARTHY exhaust without the DB Killer installed. Settings provided by Marthy.
| |
GRN @ 7 |
YEL @ 6.5 |
RED @ 6.5 |
G/B @ 3.5 |
Y/B @ 4.5 |
R/B @ 6.5 |
|
|
Recommended base settings for ARROW Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle In
| |
GRN @ 4 |
YEL @ 5 |
RED @ 3.5 |
G/B @ 5 |
Y/B @ 3.5 |
R/B @ 3 |
|
|
Recommended base settings for AKRAPOVIC CARBON exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle In
| |
GRN @ 4 |
YEL @ 6.5 |
RED @ 4 |
G/B @ 2 |
Y/B @ 3.5 |
R/B @ 1 |
|
|
Recommended base settings for M4 SLIP-ON exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected.
| |
GRN @ 6.5 |
YEL @ 7 |
RED @ 6 |
G/B @ 4 |
Y/B @ 3.5 |
R/B @ 1 |
|
|
Recommended base settings for YOSHIMURA Full System Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle In
| |
GRN @ 5.5 |
YEL @ 7 |
RED @ 6.5 |
G/B @ 4.5 |
Y/B @ 5 |
R/B @ 1 |
|
|
Recommended base settings for GRAVES Full exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle Out
| |
GRN @ 6 |
YEL @ 7 |
RED @ 7.5 |
G/B @ 3 |
Y/B @ 5 |
R/B @ 1 |
|
|
Recommended base settings for GRAVES Full exhaust with DNA air cleaner, DNA velocity cover and O2 sensor disconnected. Baffle Out
| |
GRN @ 6 |
YEL @ 7 |
RED @ 7.5 |
G/B @ 3 |
Y/B @ 5 |
R/B @ 1 |
|
|
Recommended base settings for SC Project Full System Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle In
| |
GRN @ 5.5 |
YEL @ 6 |
RED @ 5 |
G/B @ 4.5 |
Y/B @ 3.5 |
R/B @ 1 |
|
|
Recommended base settings for SC Project Full System Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle Out
| |
GRN @ 6 |
YEL @ 7 |
RED @ 5 |
G/B @ 4.5 |
Y/B @ 3.5 |
R/B @ 1 |
|
|
Recommended base settings for Ixil L3XB Full System Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected.
| |
GRN @ 5.5 |
YEL @ 6 |
RED @ 5.5 |
G/B @ 3.5 |
Y/B @ 3 |
R/B @ 1 |
|
|
Recommended base settings for Ixil SX1 Full System Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected.
| |
GRN @ 5.5 |
YEL @ 6 |
RED @ 5.5 |
G/B @ 3.5 |
Y/B @ 3 |
R/B @ 1 |
|
|
Recommended base settings for STOCK exhaust, with stock air cleaner, snorkel removed and O2 sensor connected.
| |
GRN @ 4.5 |
YEL @ 4 |
RED @ 4.5 |
G/B @ 4.5 |
Y/B @ 4.5 |
R/B @ 1 |
|
|
Recommended base settings for STOCK exhaust, with stock air cleaner, snorkel intact and O2 sensor connected.
| |
GRN @ 4 |
YEL @ 4 |
RED @ 4 |
G/B @ 3.5 |
Y/B @ 4.5 |
R/B @ 1 |
|
|
Recommended base settings for TWO BROTHERS Full System Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected.
| |
GRN @ 6.5 |
YEL @ 7 |
RED @ 6.5 |
G/B @ 4.5 |
Y/B @ 3.5 |
R/B @ 1 |
|
|
Recommended base settings for ARROW Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle Out
| |
GRN @ 5 |
YEL @ 5.5 |
RED @ 3.5 |
G/B @ 3.5 |
Y/B @ 3.5 |
R/B @ 3 |
|
|
Recommended base settings for GRAVES Full exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffle In
| |
GRN @ 6 |
YEL @ 7 |
RED @ 7 |
G/B @ 4 |
Y/B @ 5 |
R/B @ 1 |
|
|
Recommended base settings for GRAVES Full exhaust with DNA air cleaner, DNA velocity cover and O2 sensor disconnected. Baffle In
| |
GRN @ 6 |
YEL @ 7 |
RED @ 6 |
G/B @ 3 |
Y/B @ 5 |
R/B @ 1 |
|
|
Recommended base settings for the MIVV Oval Carbon Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffles In
| |
GRN @ 5.5 |
YEL @ 5 |
RED @ 5.5 |
G/B @ 4.5 |
Y/B @ 3 |
R/B @ 1 |
|
|
Recommended base settings for the MIVV Oval Carbon Exhaust with stock air cleaner, snorkel removed and O2 sensor disconnected. Baffles Out
| |
GRN @ 6 |
YEL @ 6.5 |
RED @ 7 |
G/B @ 5 |
Y/B @ 3 |
R/B @ 1 |
|
|
|
Veelgestelde vragen (FAQ)
Hoe moeilijk is de installatie?
Dankzij plug & play connectors en de juiste basisinstellingen is de montage in enkele minuten klaar.
Moet ik zelf instellingen aanpassen?
Voor Stage 1-modificaties is dit niet nodig. Voor wie verder wil finetunen, zijn de zones eenvoudig te wijzigen.
Wat merk ik tijdens het rijden met de EJK Electronic Jet Kit Gen 3.5 tune module for Yamaha MT-07 (2018+)?
Een soepelere gasaanname, krachtigere acceleratie en meer stabiliteit in elk toerengebied.
